PolyCalc

Mohr-Coulomb Envelope from Direct Shear Tests

Fit the cohesion intercept and friction angle from two direct shear tests, then use the envelope to find strength on a field plane.

Effective normal stress σ′ (kPa)Shear stress τ (kPa)0100200300050100150φ′ = 26°c′ = 23 kPaTest 1 (80, 62)Test 2 (240, 140)Field: σ′ = 180, τf = 111

Problem

Two consolidated-drained direct shear tests are run on specimens of the same overconsolidated clay. At failure, Test 1 has a normal stress of 80 kPa and a shear stress of 62 kPa. Test 2 has a normal stress of 240 kPa and a shear stress of 140 kPa. A potential slip plane in the field has an effective normal stress of 180 kPa.

The drained shear strength on that plane is most nearly:

  1. 88 kPa
  2. 105 kPa
  3. 111 kPa
  4. 140 kPa

Answer

Show steps

Given

  • Test 1: ,
  • Test 2: ,
  • Field plane:

Step 1: Friction angle from the slope

Both failure points lie on the same straight envelope, so its slope is the change in shear stress over the change in normal stress:

Step 2: Cohesion intercept

Put Test 1 into the Mohr-Coulomb equation and solve for the intercept:

Check with Test 2:

Step 3: Shear strength on the field plane

Concept

The drained Mohr-Coulomb envelope is a straight line of shear strength against effective normal stress. Its intercept is the effective cohesion and its slope is .

  • Two failure points fix the line: slope first, then intercept.
  • An overconsolidated clay can have ; a clean sand is usually taken as .
  • Use effective normal stress, not total.

Related: the shear strength lesson and the Geotechnical Engineering topic page.

Key Formulas

Notation: = shear strength, = effective normal stress, = effective cohesion, = effective friction angle.

Common Mistakes

  • (A) 88 kPa: assuming c' = 0 for a clay and dropping the intercept (0.4875 × 180 = 87.75 kPa).
  • (B) 105 kPa: drawing the envelope through the origin and Test 2 from a single test (140/240 × 180).
  • (D) 140 kPa: drawing the envelope through the origin and Test 1 from a single test (62/80 × 180 = 139.5 kPa).
  • Using total instead of effective normal stress in the strength equation.
  • Treating the slope as an angle: take the inverse tangent of the slope to get φ′ before reporting degrees, and use tan φ′ (not φ′) in the equation.