PolyCalc

Axial Deformation of a Stepped Bar Example

Find the total change in length of a two-segment bar with loads applied at the step and at the free end.

A₁ = 1,200 mm²A₂ = 600 mm²ABC50 kN30 kN1.5 m1.0 mSteel, E = 200 GPa (both segments)

Problem

A steel bar is fixed to a rigid wall at A. Segment AB is 1.5 m long with a cross-sectional area of 1,200 mm², and segment BC is 1.0 m long with an area of 600 mm². An axial load of 50 kN acts to the left (toward the wall) at the step B, and an axial load of 30 kN acts to the right at the free end C. Use GPa for both segments.

The total change in length of the bar (the displacement of end C) is most nearly:

  1. 0.125 mm elongation
  2. 0.250 mm elongation
  3. 0.375 mm elongation
  4. 0.750 mm elongation

Answer

Show steps

Given

  • AB: ,
  • BC: ,
  • 50 kN to the left at B; 30 kN to the right at C

Method 1, step 1: Internal force in each segment

Cut each segment and keep the part to the right of the cut (away from the wall). Forces to the right pull on the cut face, so they cause tension:

Method 1, step 2: Deformation of each segment

Method 1, step 3: Total deformation

Method 2 (check): Superposition of the two loads

Apply each load by itself and add the results. The 30 kN load at C stretches both segments; the 50 kN load at B only compresses AB, since nothing beyond B carries it:

Both methods give the same result.

Concept

For a bar made of segments, each with constant internal force, area and modulus, the total deformation is the sum of for each segment. The key step is finding the internal force in each segment, not just the applied loads.

  • Cut the bar inside a segment and look at the free body on the side away from the wall: the internal force balances every load on that side.
  • Take tension as positive (lengthening) and compression as negative (shortening), and keep the sign in the sum.
  • Keep units consistent: N, mm and N/mm² (MPa) give deformation in mm.

See Uniaxial Loading and Deformation () in the Mechanics of Materials section of the NCEES FE Reference Handbook.

Key Formulas

Notation: = internal axial force in segment i (tension +), = segment length, = cross-sectional area, = modulus of elasticity, = change in length.

Common Mistakes

  • (B) 0.250 mm: using only the 30 kN load and only segment BC, ignoring that AB also deforms.
  • (C) 0.375 mm: computing the 20 kN force in AB correctly but treating it as tension (adding 0.125 mm instead of subtracting).
  • (D) 0.750 mm: adding the loads (30 + 50 = 80 kN tension in AB), i.e. getting the direction of the 50 kN load wrong.