PolyCalc

Hollow Shaft Torsion Example

Find the peak shear stress in a hollow steel shaft under torque, then the angle of twist over its length.

Hollow shaft data
Outside diameter, Dₒ80 mm
Inside diameter, Dᵢ60 mm
Torque, T6 kN·m
Shear modulus, G80 GPa
Length, L (twist step)1.5 m

Problem

A hollow steel shaft has outside diameter 80 mm and inside diameter 60 mm. It carries a torque of 6 kN·m. G = 80 GPa. The maximum shear stress in the shaft is most nearly:

  1. 60 MPa
  2. 65 MPa
  3. 87 MPa
  4. 175 MPa

Answer

Show steps

Given

  • Dₒ = 80 mm, Dᵢ = 60 mm
  • T = 6 kN·m = 6 × 10⁶ N·mm
  • G = 80 GPa = 80,000 MPa

Step 1: Polar moment of inertia of the hollow section

Subtract the hollow core: use the difference of the fourth powers, not the solid-shaft value.

Step 2: Maximum shear stress at the outer surface

Shear stress is largest at the outer radius, c = Dₒ/2 = 40 mm:

Most nearly 87 MPa.

Check: Stress at the inside surface

Shear stress varies linearly with radius, so the inside surface carries less stress than the outside.

Extra: Angle of twist over 1.5 m

Convert G to MPa (80 GPa = 80,000 MPa) and L to mm so the units cancel.

Concept

Torsion of a circular shaft produces shear stress that grows linearly from zero at the center to a maximum at the outer surface. A hollow shaft carries the load with the material where it works hardest.

  • Use the polar moment of inertia J, not the area moment I used for bending.
  • For a hollow section, J is the outer value minus the inner value.
  • Convert units first: kN·m to N·mm (×10⁶) and GPa to MPa (×1,000).

Related: shaft torsion calculator and the Mechanics of Materials topic page.

Key Formulas

Notation: = torque, = polar moment of inertia, = radius to the point of interest, = shear modulus, = length.

Common Mistakes

  • (A) 60 MPa: using the solid-shaft J = πDₒ⁴/32 for a hollow shaft.
  • (B) 65 MPa: finding the stress at the inner surface (r = 30 mm) instead of the outer surface.
  • (D) 175 MPa: using the diameter 80 mm as c instead of the radius, or using the area moment I (J/2) instead of J.
  • Not converting kN·m to N·mm (×10⁶).
  • Leaving G in GPa when computing the angle of twist; convert it to MPa.