PolyCalc

Darcy-Weisbach Head Loss Example

Find the pressure drop along a straight horizontal pipe from the friction head loss.

Q = 0.050 m³/s12p₁p₂ = ?L = 300 mD = 200 mm

Problem

Water at 20°C flows at 0.050 m³/s through a straight, horizontal, 300 m long pipe with a constant inside diameter of 200 mm. The pipe wall has an absolute roughness of 0.26 mm. Assume fully developed turbulent flow.

The pressure drop between the two ends of the pipe is most nearly:

  1. 25.2 kPa
  2. 41.2 kPa
  3. 39.7 kPa
  4. 82.4 kPa

Answer

Show steps

Given

  • , ,
  • Water at 20°C: ,

Method 1, step 1: Velocity, Reynolds number, relative roughness

Method 1, step 2: Friction factor from the Colebrook equation

Iterate Colebrook, starting from a guess of :

Method 1, step 3: Head loss and pressure drop

Energy equation between sections 1 and 2:

Method 2 (check): Swamee-Jain explicit friction factor

The explicit Swamee-Jain approximation avoids iteration and should land within about 1% of Colebrook:

41.5 kPa is within 1% of 41.2 kPa and selects the same answer choice, so the result is confirmed. To check your own numbers, the head loss calculator runs the same Colebrook solution and a Hazen-Williams comparison.

Concept

In a real pipe, friction converts mechanical energy into heat. The energy equation carries this as a head loss , which the Darcy-Weisbach equation gives in terms of the friction factor .

  • In a constant-diameter horizontal pipe the velocity head and elevation terms cancel, so the pressure drop is entirely friction: .
  • The friction factor depends on the Reynolds number and the relative roughness (Moody diagram or Colebrook equation).
  • For turbulent flow (Re above about 4,000), roughness matters; a smooth-pipe formula under-predicts the loss.

See the pipe flow, Darcy-Weisbach and Moody diagram material in the Fluid Mechanics section of the NCEES FE Reference Handbook.

Key Formulas

Notation: = friction head loss, = Darcy friction factor, = pipe length, = inside diameter, = mean velocity, = absolute roughness, = specific weight.

Common Mistakes

  • (A) 25.2 kPa: using a smooth-pipe friction factor (Blasius, f = 0.316/Re^0.25 = 0.0133) and ignoring the 0.26 mm roughness.
  • (C) 39.7 kPa: using the fully rough friction factor from the relative roughness alone (f = 0.0210), which ignores the Reynolds number term in Colebrook.
  • (D) 82.4 kPa: leaving out the factor of 2 in V²/(2g), which doubles the head loss.