PolyCalc

Primary Consolidation Settlement Example

Estimate how far a clay layer settles when new fill squeezes water out of it, a standard FE geotechnical calculation.

New fill: Δσ = 40 kPaNormally consolidated clayCc = 0.30, e₀ = 1.0σ′₀ = 60 kPafirm stratumH = 4 m

Problem

A 4 m thick, normally consolidated clay layer has a compression index and an initial void ratio . The initial effective stress at mid-depth of the layer is 60 kPa. A new fill adds 40 kPa at mid-depth.

The primary consolidation settlement is most nearly:

  1. 106 mm
  2. 133 mm
  3. 266 mm
  4. 306 mm

Answer

Show steps

Given

  • Layer thickness:
  • ,
  • at mid-depth
  • at mid-depth

Step 1: Final effective stress

Step 2: Stress ratio term

Step 3: Settlement coefficient

Step 4: Settlement

Concept

When load is added to a saturated clay, pore water drains slowly and the soil skeleton compresses. The total volume change is the primary consolidation settlement. For a normally consolidated clay it depends on the compression index , the initial void ratio, the layer thickness, and how much the effective stress increases at mid-depth.

  • Use the effective stress at the middle of the layer as (see the effective stress example for how to find it).
  • The logarithm is base 10 for the standard form.
  • Keep in the units you want the answer in (mm here).

See the consolidation settlement equations in the Geotechnical section of the NCEES FE Reference Handbook. For the full theory, read the consolidation and settlement lesson.

Key Formulas

Notation: = compression index, = layer thickness, = initial void ratio, = initial effective stress at mid-depth, = stress increase.

Common Mistakes

  • (A) 106 mm: using the load increase alone in the log term, |log10(40/60)| = 0.176, instead of (σ′₀ + Δσ)/σ′₀.
  • (C) 266 mm: forgetting the (1 + e₀) in the denominator, which doubles the answer here.
  • (D) 306 mm: using the natural log (ln 1.667 = 0.511) instead of log base 10.

Note: for an overconsolidated clay, use the recompression index up to the preconsolidation stress, and only for the part of the stress increase beyond it.