PolyCalc

Method of Sections: Truss Example

The method of sections finds the force in one truss member without solving the whole truss. Cut the truss through the member you want (and no more than three members with unknown forces), then apply equilibrium to the piece on one side of the cut:

  1. Find the support reactions from the whole truss.
  2. Cut through the member you need and at most two others; keep the simpler side.
  3. Draw each cut member force pulling away from the piece (tension).
  4. Use one equation per unknown: about the point where the other two cut members meet, or when they are both horizontal.
  5. A negative answer means compression.

The NCEES FE Reference Handbook lists it under Statics, “Plane Truss: Method of Sections”. To solve every member instead, use the method of joints, or check any truss in the free truss calculator.

Worked example: force in diagonal FE

section cut18 kN36 kNAFGBCEFE = ?4 m3 m height; panels 4 m

Sketch is not to scale.

Problem

The truss shown has a pin support at A and a roller support at B. Bottom joints A, C, E and B are 4 m apart, and top joints F and G are 3 m above C and E. Loads of 18 kN and 36 kN act downward at C and E. Members are pin-connected and weights are neglected.

The force in member FE is most nearly:

  1. 6.0 kN tension
  2. 7.5 kN tension
  3. 10.0 kN tension
  4. 10.0 kN compression

Answer

Show steps

Given

  • Panel width 4 m, height 3 m (so FE is a 3-4-5 member, 5 m long)
  • Loads: 18 kN down at C, 36 kN down at E
  • Pin at A, roller at B; no horizontal load, so

Step 1: Support reactions

Step 2: Cut through CE, FE and FG, and sum vertical forces on the left side

CE and FG are horizontal, so they drop out of the vertical sum. Only R_A, the 18 kN load and the vertical component of FE remain. FE is assumed in tension, so on the left piece it pulls down and to the right.

Check 1: the other two cut members close the left piece

Check 2: method of joints (A, then C, then F)

Both methods give 10.0 kN in tension, which selects choice C.

Concept

The method of sections passes an imaginary cut through at most three members whose forces are unknown, then applies the three equilibrium equations to either side of the cut. It is faster than the method of joints when only one or two member forces are needed.

  • Assume every cut member is in tension (force pulls away from the joint). A negative answer means compression.
  • Choose the equation that isolates the unknown: a moment about the point where the other two cut members meet, or a force sum in a direction perpendicular to two of them.
  • Diagonal members carry the shear in a panel, so the vertical force sum on the diagonal gives its force directly.

Key Formulas

Notation: F = member force (tension positive), R = support reaction, θ = angle of the diagonal above horizontal.

Common Mistakes

  • (A) 6.0 kN tension: using the vertical shear (24 - 18 = 6 kN) as the member force. FE is inclined, so divide by sin θ = 3/5.
  • (B) 7.5 kN tension: dividing the shear by cos θ = 4/5 instead of sin θ.
  • (D) 10.0 kN compression: right magnitude, wrong sign. FE pulls the left piece downward, which balances the 6 kN of extra upward reaction, so it is in tension.
Check a truss in the Truss Calculator